DIY cables for WSNDB

These are 3 foot long cables for use with the WSNDB.  One side has a male-3 pin connector that plugs into an NDB output, the other side is stripped and ready to solder on to something.   This is a set of 4 cables.

 

The cable is a flat, 3 conductor, 22ga wire with silicone insulation.

The male side has markings next to the pins of + (5v), - (ground), and S (data signal).  The wire has small white dots or dashes along the +5V wire, though we always recommend you verify this with a voltmeter.   The center wire is always the data signal, and the remaining wire is ground.

 

 

Related Products